This video demonstrates an industrial leak detection sensor test using MDI and the YHSP-SA Electronic Leak Point Sensor. The test verifies no false alarms in water, reliable organic solvent detection, and successful alarm activation in less than 20 seconds.
Yoohantech continuously conducts leak detection performance tests using real industrial chemicals to verify sensor reliability, response characteristics, and field performance.
This test evaluates the leak detection capability of the YHSP-SA Electronic Leak Point Sensor using MDI (Methylene Diphenyl Diisocyanate), a widely used industrial chemical.
Before testing the MDI sample, the sensor was immersed in water for approximately one minute to verify whether any false alarm would occur.
The sensor showed no response and no alarm activation during the water test.
This confirms the sensor's ability to distinguish water from target chemicals and prevent false alarms caused by moisture, condensation, or rainwater.
After removing moisture from the sensor surface, the sensor was immersed in the MDI sample and the response time was measured under the same conditions as the water test.
The sensor successfully responded to the MDI sample and activated the alarm in less than 20 seconds.
The measured value increased from the initial reading of 1.0436 and reached the preset alarm threshold of 1.0536, confirming reliable leak detection performance.
This test confirms that the YHSP-SA Electronic Leak Point Sensor can reliably detect MDI while maintaining immunity to water-induced false alarms.
The successful detection of MDI within less than 20 seconds demonstrates the sensor's suitability for industrial leak detection, chemical spill monitoring, and process safety applications.
We confirm applicability and recommend solutions based on your target liquid and site conditions.
Setting the trusted standard for liquid leak detection in industrial facilities.